Differences

This shows you the differences between two versions of the page.

--- wiki:projects:contracts:mocap:blog [2010/06/07 00:33] – jeff
+++ wiki:projects:contracts:mocap:blog [2020/11/19 14:21] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
 ====== MoCap Dev Blog ======
+===== October 1, 2010 =====
+[[http://www.custompcb.com/]]
+===== September 9, 2010 =====
+Ok, created the first pass on the 6-DOF sensor module.  I need to do a validation check to make sure the schematic for the gyros and the 3.3v are correct.  Once I do that, I should be able to start creating the circuit.
+===== September 8, 2010 =====
+Pretty good EE tool.
+[[http://www.diptrace.com/download.php]]
+===== June 24, 2010 =====
+Someone's mocap system that is close to what I'm building.
+[[http://www.xsens.com/en/general/mvn]]
+===== June 9, 2010 =====
+Figured out why 3ds Max wasn't reading in the data.  Two things were causing problems.  The first was the tri axis sensor outputs two values, the voltage of the force and an angle for the force.  The angle data is wrong.  I took the voltage data and the reference voltage and preformed the math.  Once I was doing this process the data was working correctly.  The second issue with importing the data into 3ds Max is that max didn't like the data being inserted directly into the scene from a MAXScript file.  So, I found that File -> Load Animation -> .xaf file, is what needed to be used to load the animation.  For some reason Max uses this process to load motion capture data.
 ===== May 14, 2010 =====
-I built a board and on tri axis sensor and I'm a little stumped as to why 3ds max is torturing the data.  It's creating "noise" where there is none.  So I started looking into the power supply.  I found:
+I built a board and one tri axis sensor and I'm a little stumped as to why 3ds max is torturing the data.  It's creating "noise" where there is none.  So I started looking into the power supply.  I found:
   * 280ma propstick

wiki/projects/contracts/mocap/blog.1275870801.txt.gz · Last modified: 2020/11/19 14:21 (external edit)

Back to top